Fireplace Services in Englewood - Checked, Photographed, Then Priced

Chimney Cleaning in Englewood, CO

Chimney cleaning in Englewood, CO typically costs between $189 and $319 for a standard sweep with a Level 1 inspection, and most jobs are completed the same day. The real issue across Englewood’s housing stock isn’t just soot, it’s the mismatch between 1940s and 1950s coal-era flues and the gas appliances now venting through them. Call (980) 580-8641 for a written quote before any work begins.

Call (980) 580-8641

Why Englewood Homes Are Different

Englewood’s residential core is dominated by post-WWII brick ranch and bungalow homes built between roughly 1940 and 1965, many with original masonry chimneys designed for coal or solid-fuel burning that were later converted to vent gas appliances. These oversized coal-era flues are chronically mismatched to modern gas combustion, trapping moisture, accelerating clay-tile liner deterioration, and leaving wood-burning units prone to rapid creosote buildup. This conversion-era mismatch problem appears at a density rarely seen in newer Denver-area suburbs.

At roughly 5,400 feet on the Front Range, Englewood sits squarely in the zone affected by Chinook wind events. Rapid downslope warming can swing temperatures 40 to 60 degrees within hours on a single winter day, creating aggressive freeze-thaw cycling that cracks chimney crowns, opens mortar joints, and spalls brick faces faster than in lower-elevation cities nearby. A seasoned Englewood tech quickly learns to spot the coal-conversion tell: a large-diameter terra cotta flue tile, 12 inches or wider, now serving only a gas furnace or fireplace insert, with heavy white efflorescence bleeding down the exterior brick and chronic spalling near the crown. That pattern shows up constantly in neighborhoods like Belleview, Centennial Acres, and the older streets east of South Broadway.

Our Main Englewood Services

Beyond the sweep itself, the two services Englewood homeowners call about most involve fireplaces that need to burn correctly and chimney caps or crowns that have failed under Front Range weather.

Fireplace Services in Englewood

Original fireboxes in Englewood’s 1940s and 1950s ranch homes were built for coal grates and short, hot fires, and the refractory mortar in those boxes is now crumbling in many cases. We inspect firebox integrity, damper operation, and clearance to combustibles, then quote repairs in writing. For details on gas logs, wood-burning setup, and fireplace repair specific to this area, see our Fireplace Services in Englewood page.

Chimney Cap & Crown in Englewood

Chinook-driven freeze-thaw cycles are brutal on Englewood’s chimney crowns, and a cracked crown lets water into the brick below, accelerating spalling and liner damage. We replace crowns, install multi-flue caps, and document the before and after with photos. Read about crown repair and cap options on our Chimney Cap & Crown in Englewood page.

Before

After

Chimney Cleaning & Sweep in Englewood

Chimney cleaning in Englewood means dealing with creosote that forms quickly in wood-burning flues attached to older, oversized masonry chimneys, and with soot and moisture condensate in gas-vented coal-era flues. This is what our Chimney Cleaning & Sweep service handles every week across Englewood. The work is straightforward: remove the buildup, document flue condition with a camera scan, and give you a written report with photos.

Level 1 Inspection

Signs you need it

You use your fireplace or gas appliance seasonally and have not had the flue looked at in over a year.

What it costs in Englewood

In Englewood, a Level 1 inspection runs $129 to $199, typically bundled with a sweep.

How we do it

We check the accessible portions of the flue, damper, firebox, and exterior chimney, and document everything with a camera scan and photo record.

Creosote Removal

Signs you need it

You burn wood regularly and see black, tar-like or flaky buildup on the damper or firebox walls, or you smell a sharp, smoky odor in the house.

What it costs in Englewood

Creosote removal in Englewood costs $189 to $319 as part of a full sweep, with heavier Class III glaze removal running higher.

How we do it

We run rotary rods and brushes down the flue, remove the creosote from the smoke chamber and damper, and re-scan the flue to confirm clearance.

What Chimney Cleaning & Sweep Costs in Englewood

How often should I have my chimney cleaned in Englewood?

Once a year for wood-burning fireplaces, and every one to two years for gas-vented chimneys. Englewood’s oversized coal-era flues trap moisture, which mixes with soot and accelerates buildup, so annual service is the safe default.

Do you clean gas fireplace chimneys too?

Yes. Gas chimneys build a different kind of deposit, mostly acidic condensate and soot, but the flue still needs cleaning. We sweep and inspect gas-vented flues throughout Englewood during the same visit. Call (980) 580-8641 to schedule.

Chimney Repair in Englewood

Chimney repair in Englewood usually starts with masonry damage from Chinook freeze-thaw cycling, and the fix often involves repointing mortar joints or replacing spalled bricks before water works deeper into the flue. This is what our Chimney Repair service addresses. We quote every repair in writing after a camera inspection, so you can see exactly what needs work.

Mortar Repointing

Signs you need it

You can see crumbling or missing mortar between bricks, especially near the top of the chimney where weather hits hardest.

What it costs in Englewood

Mortar repointing in Englewood typically costs $15 to $30 per square foot, with most partial jobs falling between $500 and $1,500.

How we do it

We grind out the deteriorated mortar to a proper depth, pack in fresh mortar matched to your brick, and tool the joints to shed water.

Chimney Waterproofing

Signs you need it

You see efflorescence, white mineral staining, on the exterior brick, or moisture inside the flue during a camera inspection.

What it costs in Englewood

Chimney waterproofing in Englewood runs $300 to $800 depending on chimney height and brick condition.

How we do it

We clean the brick surface, repair any failed mortar, and apply a vapor-permeable water repellent that lets the masonry breathe while blocking rain and snow.

What Chimney Repair Costs in Englewood

Do I need a permit for chimney repair in Englewood?

Most repointing and waterproofing jobs in Englewood do not require a permit. Structural rebuilds above the roofline may, and we check city requirements before quoting the job.

Can you do chimney repair in winter in Englewood?

Yes. Cold-weather mortar and sealers are available, but Chinook-driven temperature swings can extend curing times. We schedule winter repairs for stable weather windows and confirm this at the written-quote stage. Call (980) 580-8641.

Chimney Liner & Rebuild in Englewood

Chimney liner and rebuild work in Englewood often stems from the same coal-era conversion issue: a 12-inch terra cotta flue venting a modern gas furnace creates condensate that eats the clay tile from the inside. This is what our Chimney Liner & Rebuild service corrects. We install liners sized to the appliance actually in use, not to a 1950s coal grate that no longer exists.

Stainless Steel Liner

Signs you need it

Your camera inspection shows cracked, separated, or missing clay tiles, or the flue is oversized for the gas appliance now venting through it.

What it costs in Englewood

Stainless steel liner installation in Englewood runs $2,500 to $5,500 for a single-flue home, depending on height and access.

How we do it

We size the liner to the appliance, run it down the existing flue, insulate as needed, and seal the top plate and cap.

Partial Rebuild

Signs you need it

The crown and top courses of brick are spalling or leaning, but the lower chimney structure is sound.

What it costs in Englewood

A partial chimney rebuild in Englewood, from the roofline up, typically costs $2,000 to $5,000.

How we do it

We demolish the damaged top section, rebuild the brick with fresh mortar, pour a proper crown with a drip edge, and cap the flue.

What Chimney Liner & Rebuild Costs in Englewood

Do I really need a new liner, or can I wait?

If the camera scan shows cracked tiles or the liner is oversized for a gas appliance, moisture is already working through the masonry. Waiting typically makes the repair more expensive, not less. We can show you the footage before you decide.

How long does a liner or rebuild take in Englewood?

A liner install is usually one day. A partial rebuild is two to three days, weather permitting. We coordinate around Chinook wind events, since mortar needs stable temperatures to cure properly. Call (980) 580-8641 for a written scope and timeline.

Brands We Service in Englewood

We install and service liners and caps from Famco, DuraFlex, and Copperfield, and we stock common replacement parts locally for Englewood jobs. That keeps turnaround on liner and cap work shorter than ordering from out of state. See our brands for details on the materials we trust.

Pricing for Chimney Cleaning in Englewood, CO

Neighborhoods We Serve in Englewood

We work throughout Englewood’s older residential core and the surrounding streets, with most jobs scheduled within a few business days of your call.

• Belleview
• Centennial Acres
• Cherry Hills Village
• South Broadway corridor
• Englewood downtown

Service Area - Cities Near Englewood

We serve Englewood and the surrounding Denver metro communities, including Littleton, CO, Denver, CO, Aurora, CO, and Wheat Ridge, CO. Scheduling is coordinated from our Denver office, with crews dispatched locally across the Front Range.

FAQs About Chimney Cleaning in Englewood